Hola de nuevo.
No quiero ser pesado pero estoy un poco despistado pues ya he visto que Mariner en su manual dice que el motor parado, pero tengo el de Tohatsu en inglés (no tengo en castellano) y en el apartad "Washing outboard motor",dice esto:
■
Use flushing attachment.
①
Remove propeller (refer to Propeller
Replacement). Remove the water
plug from the motor, and screw in
the flushing attachment.
②
Attach a water hose to the flushing
attachment. Turn on the water and
adjust the flow. (Be sure to seal
the water inlet, located in the gear
case, with tape.)
③
Start the engine and run it at idle
speed in neutral shift position.
④
Check for a steady stream of water
flowing out of the water pump
indicator hole. Continue flushing
the outboard motor for 3 to 5
minutes, carefully monitoring water
supply at all times.
⑤
Stop the engine, turn off the
water, and remove the flushing
attachment and tape. Reinstall the
propeller