[flipk12]

Ok. Cierto. Mis disculpas

The SeaTalk bus with all other devices except the autopilot control heads must now be disconnected from the power supply - this can also be the red terminal of the SeaTalk connector on the course computer. It is best installation practice for SeaTalk 1 devices (except ST 1 autopilot control heads) that these devices receive their power from the SeaTalkng / NMEA 2000 backbone via the SeaTalk connector on the SeaTalk to SeaTalkng converter. The SeaTalkng power cable from the SeaTalk to SeaTalkng converter kit must be connected to a 5A 12VDC fuse on the switchboard and then to a free white spur connection on the SeaTalkng / NMEA 2000 backbone; it is important to keep the SeaTalkng / NMEA 2000 backbone LEN loads evenly distributed on either side of the feed (balanced system).