Electrónica Pantalla raymarine c80 falla

[peleon]

Esta es la respuesta a la consulta que hice en este foro yanqui, por el mismo problema en mi plotter.
Parece fácil, pero yo no me he atrevido (por ahora, porque de momento funciona) a hacerlo.
Espero que te sirva, y que comentes el resultado si lo haces.



Reply to thread 'Raymarine C70 Plotter screen issues'‏


Reply to thread 'Raymarine C70 Plotter screen issues'
Cruisers & Sailing Forums Agregar a contactos 25/03/2016 Conservar este mensaje en la parte superior de la bandeja de entrada
Para: jjberdion@hotmail.com
support@cruisersforum.com
Dear Peleon,

Kinvig has just replied to a thread you have subscribed to titled - Raymarine C70 Plotter screen issues - in the Marine Electronics forum of Cruisers & Sailing Forums.

This thread is located at:
http://www.cruisersforum.com/forums/...-new-post.html

Here is the message that has just been posted:
***************
It's fairly easy to do. Take off the cover and unscrew all of the screws round the screen. Then take the unit apart. To there are ribbon connectors between the boards. Just flip up the connector and they come out. From memory you need to take the first 2 boards off. I think someone else has posted a picture of the connector. There is a screw that is a fraction too long in the board which over time pushes the connector out. 2mm off the end with a small hacksaw and job done. Took me about an hour and been fine since. Just need some small screw drivers and a hack saw. Hope that helps.
***************


There may also be other replies, but you will not receive any more notifications until you visit the forum again.

All the best,
Cruisers & Sailing Forums