Electrónica Unir MNEA Piloto ST2000 y gps Garmin 73

[Leeway]

Addenda, del manual de mi piloto SIMRAD TP20:




Interfacing Via NMEA
The Tillerpilot’s state-of-the-art electronics include a
built-in NMEA processor, which means that
NMEA0183 compatible equipment can be connected
directly to the Wheelpilot, without any need for a sep-
arate interface unit (Fig 5.6).
Due to the vast number of different manufacturers and
models of navigational equipment, Simrad cannot
guarantee correct operation and installation of this
equipment. Therefore, before connecting any equip-
ment to the Tillerpilot it is important that the unit’s
manual is referred to with regard to interfacing via
NMEA.
When connecting to the Tillerpilot’s NMEA interface,
two wires are used - a DATA wire and a COMMON
(Com) wire. These should be connected to the six-pin
bulkhead socket as follows:


(Ver imagen)



It should be noted that some manufacturer’s equip-
ment does not have a dedicated Common connection.
In this case, the DATA connection will usually be
labelled NMEA OUT, and the NMEA Common con-
nection on the Tillerpilot (terminal 5) should be con-
nected directly to 0v (terminal 2). If in any doubt,
refer to the manufacturer, or Simrad’s Product
Support department for advice