Otros Error calefacción WEBASTO

[NPI]

aqui tienes los codigos de error..

An error code is generated on the control element indicator light after an error has occurred. When determining the
generated code, there will be a series of 5 fast flashes after which, the error code will be generated by a sequence of
long flash pulses, count only the long flash pulses to obtain the code. Error codes are shown in the table below.
If the heater is fitted with a combination timer, an error message will appear on the display of the timer after a fault
occurs. If the control element is used, the error number is indicated by the indicator light flashing:
F 00 Control unit error / incorrect parameter set / warm start recognition
F 01 No start (after 2 attempts to start) / no flame formation
F 02 Flame failure (repeated more than 3 times)
F 03 Under voltage or over voltage
F 04 Premature flame recognition
F 06 Temperature sensor interrupt or short circuit
F 07 Metering pump interrupt or pump short circuit
F 08 Fan motor interrupt or short circuit or overload or blocked
F 09 Ceramic glow pin interrupt or short circuit
F 10 Overheating: Resulting in permanent heater fault lock-out
F 11 Overheating sensor interrupt or short circuit
F 12 Heater lock-out
F 13 Heater lock-out permanent
F 14 Overheating sensor incorrect position
F 15 Set point generator interrupt

Seguramente son 5 + 2. Como ves 2 es error de llama. O no llega combustible o esta sucio el quemador.

A mi me paso lo mismo y era aire en el tubito de combustible. Lo saque, un poco de succion para sangrarlo y listo...